Fahrenheat FFH Small Wall Heater•The following pictorial is astep by step installationguide. It will show theinstallation in a newconstruction situati
Step 8•Connect the REDwire from thethermostat to theWHITE wire (w/blackmarker) from thepower cable, usingwire nut included.
Step 9•Connect the BLACKwire from thethermostat to theBLACK wire from thepower cable, usingwire nut include.
Step 10•Once you have thewire connectionsmade and checked,tuck the wires neatlyinto the top of theback box and insertthe inner frame.•Using the screws
Step 11•Verify the unit hasbeen installed withthe arrow pointing up.•The fan blade will beat the bottom wheninstalled correctly.
Step 12•Install the grille withthe painted screwsprovided•Install the knob ontothe shaft of thethermostat.
Test Procedure/Operational Guide•Adjust the thermostat to the fullcounterclockwise position (off).•Turn on the power at the main disconnect.•The heate
Test Procedure/Operation Guide•To adjust the thermostat, turn the knob to the fullon position and let the unit run until the roomreaches a comfortable
WARNING•Before installing this electric heaterread and understand the instructionmanual.•The following minimum clearances mustbe maintained:–Heater to
Installation Instructions•Verify the Nameplate rated VOLTAGE &ERAGE prior to installation.•Size the wire and breaker for the amp loadof the hea
Step 1•Note: For new constructioninstallation the edge of theback box must be installedflush with the finishedsurface.1.Determine which side ofthe bac
Step 2•Remove the knockout(KO) in the upper leftof the back box•Install a cable clampin the knockout (notprovided)
Step 4•Insert power cablethrough the cableclamp and allow atleast 6” of wire toenter the back box.•Tighten the cableclamp so the wire issnug and held
Step 5•Connect the greenground wire from theback box to theground wire of thepower cable with awire nut.
Step 6•This heater is equipped witha Clip-N-Fit board. You canpermanently change thewattage output of the heateras desired. Read theinstruction manual
Step 7•Locate the two pigtailwires from thethermostat. These wireswill be used to connectthe power supply to theheaterNote: In new construction,do not
Kommentare zu diesen Handbüchern